The FanZip® Insulator is a simple solution to a major problem in homes with attic whole house fans. The FanZip® Insulator is a simple solution to a major problem in homes with attic whole house fans. Traditional whole house fans leak air between the attic and living spaces. This can result in dirty cold or hot attic air entering your home. On the other hand, air leakage through the whole house fan from your home can create a negative pressure in your home. This negative pressure can draw outside air into your home through your fireplace or other unsealed openings.Whether the external air enters your home from outside through unsealed openings or leaks through your whole house fan, it makes your air conditioning and heating unit run longer. In cold climates, infiltration of warm moist air into your attic can cause water damage through condensation and may create ice. Preventing attic air leaks into your living space is the most efficient way to lower your energy costs and prevent problems in your home or attic.
Save up to 20% on HVAC Energy Costs by Air Sealing and Insulating your home.1 FanZip®Attic Fan Insulator unit attaches to the attic side of the whole house fan frame. It, in effect, seals off the opening in your attic stopping either the superheated or super-cold air in the attic from invading the living area. It uses a zippered top with a low profile opening for easy access to service the fan motor or belt. Now you can use the FanZip® Attic Fan Insulator to effectively seal and insulate your whole house fan. The FanZip® Attic Fan Insulator prevents radiant heat from entering your home in the summer and leaving your heated areas in the winter. The Seal N Shield®FanZip™ Insulator provides an effective seal against drafts, heat/air conditioning loss and is an easy-to-install unit. The FanZip Attic Fan Insulator has an effective R Value of 13. If desired additional insulation can be installed over the insulator during downtime between seasonal use.
The FanZip® Attic Fan Insulator may be installed on direct drive fans or belt drive fans. The insulator fits many of the major manufacturers whole house fans. The Seal N Shield® FanZip®Attic Fan Insulator will fit most of the following manufacturers fans:
♦ Master Flow Fans
♦ Air Vent Fans
Engineering(Some models may require an extension installed on the motor side of the frame.)
CLICK HERE for a list of FanZip® Models that standard insulators are manufactured to fit.
Fits most other whole house fan manufacturer frames that measure approximately 28 inches square and 46 inches square. The frame can be slightly smaller or larger by one inch. Larger sizes and custom sizing are available upon request. Start Saving Money Today!
FanZip® Product Insert Information